The Dana/Spicer 70 axles are identified with a manufacturing date (1) and Bill of Material number 1/8" high metal stamp (2) stamped on the right or left hand tube on driving axles. The Bill of Material number may also be found on the carrier in some models as shown in illustration (2A). For independent front suspension (IFS) axles, the B/M number may be located at one of three locations: 1). A vertically positioned tag near the center of the right hand side support arm, 2) stamped into the left hand side support arm (opposite end of the camber adjuster), or 3) stamped into the "nose end" of the axle carrier. The location of the information will depend on the manufacturing date of the axle.  The axle model number will be cast into one of the webs as shown (3), or it can be on the nose.  Each axle contains a gear ratio tag (4), and if the axle is equipped with a limited slip differential, it will have a tag specifying the type of limited slip lubricant to be used (5).

With this number we can tell you exactly what components the factory used in the assembly of your differential.  You can also the following link below to research exactly what parts you need, following step 1 and then step 2 and then enter your bill of material number:  You will see a detailed list of parts and part numbers for your application.

You get the right parts the first time!  Once you know the bill of material number give us a call or down load and refer to the appropriate parts catalog listed for your bills of material number.  The parts catalog contains exploded views, parts listings, bill of material tables, and variable parts tables for each series is listed below to help you identify the parts you need: