Rebuild Kits and Parts Model 18 1940-1972 / Model 20 1973-1981 / Model 300 1980-1986

Having problems with your Dana 18, Dana 20 or Dana 300 transfer case, need rebuild kit or parts?  We offer quality transfer case parts and rebuild parts kits that are designed to be top of the line overhaul kits. The Dana 18, Dana 20 or Dana 300 was installed in Jeep Grand Cherokee 1992-98. These New Process cases have a circular tag on the rear of the case, near the center close to where the rear drive shaft exits. Identification information for the Dana 18, Dana 20 or Dana 300 transfer case is on this tag typically includes model number, assembly number, serial number and ratio data. When ordering a replacement transfer case it's most important to provide the assembly number. This number is typically eight digits, four numbers a rivet/screw head and four additional numbers.

A cross reference table is provide to assist you in identification of your transfer case. Check tag located on rear of unit for model number. An illustrated drawing is provide below to assist you in parts identification, ordering and assembly.   Back to other model transfer case parts availability page, sometimes we can supply good used take out parts to save you money.  Don't see what you need just give us a call toll free 800-216-1632.  If you decide to replace your Dana 18, Dana 20 or Dana 300 transfer case with a remaufactued unit with a 12 month warranty see our complete list of transfer cases for  Jeep  vehicles.  All rebuilt transfer case get new seals, bearings, chains, fork pad, encoder motors and viscous couplers.  All shafts, slider, hubs and planets are inspect to ensure proper tolerances are maintained. All units are tested at the factory prior to shipment.

The following table presents a list of Master Bearing Overhaul Kit, that include all major bearngs, gaskets and seal.  Dana 18, Dana 20 and Dana 300 .