DurRaptor Programmer
|
|
2001 2001 - 2003 Duramax GM Diesel now available! |
|
|
|
|
In a matter of minutes see a dramatic increase
of horsepower and torque from your Duramax!
Our Programmer improves the efficiency of your vehicle by enhancing these key areas:
* Improved throttle response
* Quicker transmission shift
* Increased fuel economy
* More passing power
* More pulling power |
|
80 horsepower 200 additional foot pounds of troque.
The only GM certified programmer outside the GM organization
designs our programmer and codes. Our code updates take advantage the ECM program
to effect critical function like the amount of fuel delivered by the injector to
increase performance (holding injectors open longer). Unlike other manufactures Duramax
performance products our programmer does not increase fuel pressure to point where
fuel rails are being destroyed.
You’re cost $690.00 + S&H install code in 5 minutes
or less.
|
Instructions for the Duramax Hand Held Programmer:
The Duramax Programmer will run automatically when the unit is inserted into the
DLC connector. Please read all the instructions before you install the unit. Any
damage to the PCM or DurRaptor Programmer as a result in not reading directions will
be at the consumer's risk.
Things you must do prior to installing your Duramax Programmer:
- Start the vehicle and allow to run for 5 minutes.
- While the vehicle is running turn of all accessories (radio,
fans, radar detectors, etc.) and set the parking brake (important). Duramax Programmer
uses battery power to reprogram the PCM. Turn off the engine.
- Install the supplied cable into the Duramax DurRaptor Programmer
and tighten thumbscrews. Turn the ignition key to the "on" position, but
do not start. Engine must not be running.
- Install the Duramax Programmer DLC (Data Link Connector)
into the DLC on the vehicle. This connector is located under the dash just side of
the steering wheel. Once installed, do not disturb the connection, damage to the
PCM could result!!!
- Both lights on the Duramax Programmer will come on, and
then the green light will begin to blink indicating that the unit is programming
the PCM. After approximately 2 minutes the green light will stay on, this indicates
that the programming was successful.
- After green light stays on, turn off key and unplug Duramax
Programmer then restart vehicle.
- If the unit had problems, the red light will begin to blink
out a trouble code. Record the trouble code and call your distributor with the code
The trouble codes are the number of times the red light blinks between pauses. Blink,
Blink, Blink pause would be a 3. Trouble codes range from 1-7. Turn the ignition
key off and wait 30 seconds prior to starting the vehicle. If the vehicle starts
and then stalls, remove the negative battery cable for 1 minute and then restart
the vehicle.
This is definitely a (DIY) do it yourself project that can be completed in less than
15 minutes. Click here for a back to Programmer.
From time to time we offer specials discounts to
our registered Internet customers, click below to register and receive advance notice
of new products, special bonus offers and to be eligible for our free random gift
drawings, we protect your e-mail address we, don't sell, trade or abuse it. Click Here to Sign UP
Orders Shipped the same day!! Most credit
cards accepted.
If it's a part and or a components
under your vehicle we can supply it!
Or you can call the order desk at 1-800-216-1632,
talk to a knowledgeable technician.
Considering purchasing manual transmission
or parts from drivetrain.com and have questions contact Tech line at 1-702-876-3100
or send e-mail to ujoints@drivetrain.com
Drivetrain Specialists of Las Vegas - Las Vegas
NV, 89102
A Division of Drive Line Service of Las Vegas
Las Vegas Nev
