Clutch and Clutch System Failures and How to Prevent Some of Them!

Having clutch problems, noise, will not release, hard to engauge, etc, before you or your mechanic rip out your clutch you may want to review this article, gaining insight and maybe saving future problems. driven_to_perfection_large.jpgAll too often the installer places the car on the rack and starts to pull out the transmission without asking:


Why did this clutch fail?
Is the failure due to normal wear and tare, or did something else cause this problem?

This is the most important step in repairing the vehicle. The best indication that this clutch system might have failed for unusual reasons is the mileage. From the 1950?s through the 1970?s, 50,000 to 60,000 miles of usage was considered a good life span for a clutch. However, with improvements in technology, clutch systems are lasting a lot longer these days. It is quite common for a clutch system to last more than 80,000 miles. It all depends on the driver, the usage of the vehicle and the maintenance of the system.

With today's improvements in clutch systems, you should be suspicious of a clutch system that failed before 35,000 miles. You should search for reasons other than normal wear and tear. If you can?t detect the cause of failure the first time, you will be dealing with it again.

Some clutch failures are not caused by a component of the clutch system, so just removing and replacing clutch components will not solve the problem of premature failure. It is quite possible that this is a problem the you or the mechanic cannot fix. In some cases, fixing the problem means changing your driving habits. In others, it might mean that you should buy a larger truck to tow that fifth-wheel trailer.

Unless you can identify the cause of the failure. It is in your best interest to determine what caused this clutch system to fail. Acting too quickly to remove the components from the vehicle can eliminate some clues as to what really happened. Taking time for a few simple diagnostic steps can enhance your ability to determine why this clutch failed.

If your vehicle is drivable, take it for a test drive. Try to re-experience the details and symptoms of the problem. Knowing exactly what the symptoms are will allow you to focus on the probable cause and will save you a great deal of time The most-common clutch-system complaints are:
*  No release- preventing shifting.
*  Slipping
*  Clutch chatters or shudders
*  Noise
*  The vehicle will not move.

Most of these common clutch-system failures can be broken down into the following categories as to causes:

*  Normal system wear or failure
*  Driver or system abuse
*  Installation failures
*  Lack of maintenance
*  Manufacturing defects.

In speculating as to what might have caused the failure, here is a general guideline as it relates to the mileage. Obviously there are exceptions, but as a rule of thumb, manufacturing defects or installation problems usually occur immediately or shortly after the installation of a new clutch kit. Problems caused by lack of maintenance and abuse usually show up in the mid-life of the clutch system- anywhere from 20,000 to 35,000 miles. Failures from normal wear and tear generally occur after more than 50,000 miles.

Asking yourself the following questions might shed some light on what caused the failure:

*  Is that the original clutch or has it been replaced? If it has been replaced, who did the work? Chances are the clutch was installed incorrectly.
*  Has the vehicle been taken in to have the clutch adjusted? Some cable-operated and some hydraulic systems are self-adjusting, but several are not. If the vehicle requires adjustment, were you aware of that?
*  If the vehicle is a truck or is equipped with a trailer hitch, what is it hauling or towing? You may need a heavy-duty replacement clutch system.

Also, and important issue is who is driving the vehicle. Let?s face it; we all in our youth liked to break those tires loose every once in a while, is there a teenager in the picture, does your wife ride the clutch at stop lights?

Some of these questions may seem a little delicate, but if one of these problems is the reason the clutch system failed, you will be fixing the vehicle over again and again. It?s best to identify these types of problems early, before the repair.

Next step is to examine the vehicle itself. Is there any collision damage? If there is, it is possible that the frame is damaged, and this could misalign the engine and transmission, causing release problems. A broken transmission mount or engine mount also could misalign the drivetrain. If any of these conditions exist, they need to be repaired before you replace the clutch or else you will experience the same problems.

Examining the underside of the drivetrain for oil leaks, especially around the bottom of the bell housing. If oil is present, it could be that the rear main seal off the engine or the front seal of the transmission needs to be replaced. Oil contamination of the clutch disc will cause slippage and eventually burn up the facing.

Next check the clutch-release system. If the vehicle has a mechanical or cable release system, check for free play at the clutch fork. The failure may have been caused by an incorrect adjustment. If the free-play adjustment was insufficient, the cover diaphragm or levers began to rise toward the bearing as the facing of the clutch disc began to wear. If the bearing was in continuous contact with the diaphragm, the clutch cover became partially engaged and allowed the clutch disc to slip, thus burning up the disc. If the problem is non-release on a vehicle with a cable system and the cable cannot be adjusted further, replace the cable. Clutch cables stretch and need to be inspected with every clutch replacement.

If the vehicle has a hydraulic clutch system, check for hydraulic leaks at the slave cylinder or the master cylinder. If either or both are leaking, they should be replaced. If the problems is non-release, replacing these components could correct the problem.

If the problem is noise coming from the clutch system, a simple test can identify the source of the noise before you tear into the system. There are two potential bearing-noise makers in the clutch system-the release bearing and the pilot bearing. To determine which one, if either, is making the noise follow these steps:

Step 1 With the engine running and the transmission in neutral, if the noise occurs it is in the transmission, most likely the front bearing supporting the input shaft.


Step 2 If that is not the problem, place your foot on the clutch pedal and begin to depress the pedal. If you begin to hear the noise at this point, the problem is the clutch release bearing. If not, proceed to the next step.


Step 3 Push the clutch pedal all the way to the floor. If you hear the noise at this point it is the pilot bearing or bushing. If you do not hear any noise during this test, the problem is not in the clutch system. Identifying these conditions early before removing and replacing the components goes a long way toward preventing a recurrence of the problem.

As you remove the clutch components from the vehicle, look for wear on components you normally don?t replace, like the clutch fork and ball stud. If they are worn, replace them. Inspect the quill, or front-bearing retainer sleeve, of the transmission for wear. If it is worn, replace it. If the quill is part of the from transmission case and cannot be removed as in some models of the Ford Escort, Taurus, and Tempo and the Mercury Topaz, repair kits are available.

And most important, when you re-install the clutch, install a complete matched set clutch kit when purchasing clutch kit be sure to ask for and get warranty. Warranties are available up to 12 months on standard kits and even out to 24 months with high performance clutch assemblies. Also another overlooked or thought not to be worth it is the resurface the flywheel do not skip this critical step.

A few simple steps before you tear it down can save you time, effort and profits in the long run- not to mention a very happy clutch system when you can identify the cause of the clutch system?s premature failure and prevent it from happening again.

This is a reprint of an article from Transmission Magazine. You may want to subscribe to this very informative magazine if you are into automotive repair.

Select on of the following links to locate the clutch that is available for your vehicle: 

We offer free technical support to assist you in solving your automotive problems as well as a large list of the following products to improve your vehicles performance, safety, economy and apperance: